Replies to This Discussion

Permalink Reply by Behnam(Ben) Nazemof on May 30, 2010 at 1:43am

Hi there,

I have had a limited experience with Dibbler and I used the following link as guideline :
http://ipv6int.net/software/dibbler_dhcpv6.html
Hope it helps!



Regards,
Behnam

Permalink Reply by mahdieh on May 30, 2010 at 1:52am

dear behnam,
i have seen this page befor,i have even reed the usergide of dibbler but i don't have enough information.
if you have used it befor whould you help me with wnough detail?
thanks alot.

Permalink Reply by Behnam(Ben) Nazemof on May 30, 2010 at 3:52am

I do my best to help you out but first explain a bit about your test environment and steps you have taken to configure the DHCPv6 via Dibbler?


Cheers,

Permalink Reply by mahdieh on May 30, 2010 at 3:59am

i just have testlab with 2 xpclient and one server2003 included 2 NAC.
first i configured stateless ipv6 addressing.and it was ok and i've checked whatever i neede.
but for statefull i tryed to reed dibbler i haven't get enough to run it.however i installed it and reed the user gide but it did't help me.
i need to know how should i use dibbler to run DHCPV6.
thanks

Permalink Reply by Behnam(Ben) Nazemof on May 30, 2010 at 4:24am

Using dibbler is rather a time consuming matter and you should read different examples and guidelines. I am not sure I can explain it all to you on here as it is not convenient nor I have advanced experience with it.

I can suggest another source which helped me to configure it on Linux environment, but I believe the principles are the same, check the pdf file attached.

Attachments:

• dibbler-user.pdf, 1.2 MB

Permalink Reply by mahdieh on May 30, 2010 at 5:08am

Thanks a lot for your help and concideration,
Dear Behnam.